copyright 1998-2017 by Mark Verboom
ipv6 ready RSS Feed Schakel naar Nederlands

Go back to Opel Speedster 2.2 16v

CG Lock

Although preparations are on their way to install harnesses in the car, I wanted a short term solution to at least get some more feedback from the car. So I got a CG Lock :)

img

The installation is super simple. Just bolt the base to the inside of the seatbelt clip (I used the short screws).

img

Should basically look like this (be sure to set it tight enough so it will not move).

img

Then get the slider and put it on, pulling down on the lever.

img

That's it!

img

Just push the lever down when grabbing the seat belt to put it on. When it is in place, pull the shoulder part and the lap part will tighten and not roll back. It is not as good as a harness, but it makes you a lot more one with the car :)